PX30-uQ7 User Manual

• 1. Introduction
  • 1.1. Device Overview
• 2. First Steps
  • 2.1. Insert the Module
  • 2.2. Mount the Fan (optional)
  • 2.3. Power Up
• 3. Using the EVK
  • 3.1. Evaluation Board Overview
  • 3.2. Power Supply
  • 3.3. Control Buttons and Switches
  • 3.4. CPU Fan
  • 3.5. Boot Order
  • 3.6. USB Serial Console
  • 3.7. RS-232 and RS-485
  • 3.8. TTL UART
  • 3.9. Ethernet
  • 3.10. SD-Card
  • 3.11. USB Interfaces
  • 3.12. Display and Camera
  • 3.13. RTC
  • 3.14. SPI and I2C
  • 3.15. GPIOs
  • 3.16. Audio
  • 3.17. CAN Bus
  • 3.18. CTRL I/O Connector
  • 3.19. MISC Connector
  • 3.20. JTAG Connector
• 4. Software Overview
  • 4.1. Supported Distributions
  • 4.2. Compiling Linux Applications
• 5. Debian image guide
  • 5.1. Prepare the host PC
  • 5.2. Compile the ATF
  • 5.3. Compile U-Boot
  • 5.4. Compile the Linux kernel
  • 5.5. Building the debos image
• 6. Building a Yocto image
  • 6.1. Prerequisites
  • 6.2. BSP meta layer
  • 6.3. Extended meta layer
• 7. Deploy a disk image
  • 7.1. Deploy on SD Card
  • 7.2. Deploy on internal eMMC
• 8. Wifi
  • 8.1. Antenna
  • 8.2. Connecting to a Wifi network
  • 8.3. Flashing the wifi firmware
• 9. Serial Number & MAC Address
  • 9.1. Serial Number
  • 9.2. MAC Address
• 10. Mule Companion Controller
  • 10.1. Companion Controller 1 (STM32)
  • 10.2. Companion Controller 2 (ATtiny)
• 11. Phosh graphical shell
  • 11.1. Usage
  • 11.2. Known issues
• 12. Hardware Guide
  • 12.1. Q7 Implementation
  • 12.2. Q7 Connector Pinout
  • 12.3. Signal Details
  • 12.4. On-board Devices
  • 12.5. Wifi and Bluetooth module
  • 12.6. USB
  • 12.7. Using Qseven Signals as GPIO
  • 12.8. Electrical Specification
  • 12.9. Mechanical Specification
• 13. Revision History